How to sew
12.Placing a collar core (Mitsu-eri-sin)
|
Place collar core on the rear neckline. Prepare a bleached cloth (10.8 cm wide × 26 cm long). |
|
|
Aligning the raw edge of the collar core and the collar seam, bind the collar core to the seam allowance adjusting the center of the collar core and center of the collar to meet. |
|
Lay the collar cloth flat to the tip and adjust the seam allowance of the collar core and the tip of the strip. Stretch out the slack in the seam allowance of the front body panel completely, mainly around the tip of the strip. |
|
|
|
Fold the width of the collar to the finished line and mark with pins. Sew the left side in similar style. |
|
|
|
Tying the tip of the collar |
|
|
|
↓↓For Men's Yukata↓↓ 
|
|
|
Turn over the seam allowance of the collar tip, straighten it out and sew 0.5 cm outside the tip. |
|
|
|
Pull out the seam allowance of the collar tip a little to the back side and fold down, wrapping and closing it with the back of the collar. Turn it over to the right side and adjust. |
|
|
|
Overlap the back side of collar 0.2 cm over the seam line, mark with pins, and sew with even slipstitches. |
|
|
|
↓↓For Men's Yukata↓↓ 
|
|